8D Consent 2007 1001 - Laserfiche WebLink

Home

F. Section 903.12 of the Uniform Plumbing Code is hereby deleted. G. Sections 903.3 -Materials of the Uniform Plumbing Code - is hereby deleted and replaced to read as follows: Vent fittings shall be cast iron, galvanized malleable iron or galvanized steel, copper, brass, stainless steel 304 or 316L, or other approved materials, except that no galvanized malleable iron or galvanized steel, or 304 stainless steel shall be used underground and shall be kept at least six (6) inches (152 mm) aboveground. Stainless steel 304 pipe and fittings shall not be installed underground and shall be kept at least 6 inches (152 mm) aboveground. H. Section 1003.1 -Materials of of the Uniform Plumbing Code - is Each trap, except for traps within an interceptor or similar device, shall be self-cleaning. Traps for bathtubs, showers, lavatories, sinks, laundry tubs, floor drains, urinals, drinking fountains, dental units, and similar fixtures shall be of standard design and weight and shall be of cast brass, cast iron, lead, PP, ar other approved material. An exposed and readily accessible drawn-brass tubing trap, not less than 17 B&S Gauge (0.045 inch) (1.1 mm), maybe used on fixtures discharging domestic sewage. L Section 1101.3 Materials Uses is hereby deleted and replaced to read as follows: Rainwater piping placed within the interior of a building or run within a vent or shaft shall be of cast iron, galvanized steel, wrought iron, brass, copper, lead, stainless steel 304 or 316E (stainless steel 304 pipe and fittings shall not be installed underground and shall be kept at least six inches (152 mm) aboveground), or other approved materials, and changes in direction shall conform to the requirements of Section 706.0. J. Section 1102.12 -Materials of the Uniform Plumbing Code - is hereby deleted and replaced to read as follows: The inside of conductors installed above ground level shall be of seamless copper water tube, Type K, L, or M; Schedule 40 copper pipe or Schedule 40 copper alloy pipe; Type DWV copper drainage tube; service weight cast-iron pipe or hubless cast-iron soil pipe; standard weight galvanized steel pipe; stainless steel 304 or 316E (stainless stee1304 pipe and fittings shall not be installed underground and shall be kept at least 6 inches (152 mm) aboveground). Section 7-5-920: FEES FOR PERMITS AND INSPECTIONS. Section 103.4 of the Uniform Plumbing Code is hereby deleted and replaced by Section 108.2 of Article 1 Section 108 of the San Leandro Municipal Code Section 7-5-925: ADMINISTRATION AND ENFORCEMENT. In order to provide the proper administration and enforcement of this Code, the provisions hereinafter set forth shall be applicable.