Ord 1998-009 - Laserfiche WebLink

Home

(e) Roof - mounted antennas and associated equipment shall be located as far back from the edge of the roof as is technically feasible in order to minimize visibility from street locations. Where appropriate, construction of a rooftop parapet or wall to hide the antenna may be required. 5. Federal and State Requirements. All towers must meet or exceed cut standards and regulations of the FAA, the FCC, the California Public Utilities Commission and any other agency of the federal or state government with the authority to regulate towers and antennas. If such standards and regulations are changed, then the owners of the towers and antennas governed by this Section shall bring such towers and antennas into compliance with such revised standards and regulations within six (6) months of the effective date of such standards and regulations, unless a more stringent compliance schedule is mandated by the controlling federal or state agency. Failure to bring towers and antennas into compliance with such revised standards and regulations shall constitute grounds for the removal of the tower or antenna at the owner's expense. D. Permitted Uses. 1. Orarernl. The uses listed in this Subsection D are deemed to be permitted uses in industrial and commercial zoning districts and shall not require Board of Zoning Adjustments review unless the applicant seeks a modification of the guidelines set forth in Subsection C.4. Nevertheless, all such uses shall comply with Subsection C.4., unless a modification is granted, and Subsection CA. of this Section and all other applicable legal provisions. 2. Specific Permitter) Uses. The following uses are specifically permitted: (a) Locating a tower or antenna, including the placement of additional buildings or other supporting equipment used in connection with said tower or antenna, in any industrial or commercial zoning district; provided, however, that such tower shall be set back from all existing off -site residences a I