8E Consent 2010 1018 - Laserfiche WebLink

Home

• D. Sections 701.2 - Materials of the Uniform Plumbing Code - is hereby deleted and replaced to read as follows: 701.2 Materials for drainage fittings shall be in accordance with the applicable standards referenced in Table 7 -1 of the same diameter as the piping served, except that ABS and PVC installations are not allowed, and such fittings shall be compatible with the type of pipe used. E. Section 903.1.2 - Materials of the Uniform Plumbing Code - is hereby deleted and replaced to read as follows: 903.1.2 ABS and PVC vent piping and fittings are not allowed. F. Section 1003.1 — Materials of of the Uniform Plumbing Code — is hereby deleted and replaced to read as follows: 1003.1 Each trap, except for traps within an interceptor or similar device, shall be self - cleaning. Traps for bathtubs, showers, lavatories, sinks, laundry tubs, floor drains, urinals. drinking fountains, dental units, and similar fixtures shall be of standard design and weight and shall be of cast brass, cast iron, lead, PP, or other approved material. An exposed and readily accessible drawn -brass tubing trap. not less than 17 B &S Gauge (0.045 inch) (1.1 mm), may be used on fixtures discharging domestic sewage. G. Section 1101.3 — Material Uses — is hereby deleted and replaced to read as follows: 1101.3 Rainwater piping placed within the interior of a building or run within a vent or shaft shall be of cast iron, galvanized steel, wrought iron, brass, copper, lead, stainless steel 304 or 3I6L (stainless steel 304 pipe and fittings shall not be installed underground and shall be kept at least six inches (152 mm) aboveground), or other approved materials, and changes in direction shall conform to the requirements of Section 706.0. H. Section 1102.1.2 - Materials of the Uniform Plumbing Code - is hereby deleted and replaced to read as follows: 1102.1.2 The inside of conductors installed above ground level shall be of seamless copper water tube, Type K, L. or M; Schedule 40 copper pipe or Schedule 40 copper alloy pipe; Type DWV copper drainage tube; service weight cast -iron pipe or hubless cast -iron soil pipe; standard weight galvanized steel pipe; stainless steel 304 or 316L (stainless steel 304 pipe and fittings shall not be installed underground and shall be kept at least 6 inches (152 mm) aboveground). Section 7 -5 -920: FEES FOR PERMITS AND INSPECTIONS. Section 103.4 of the Uniform Plumbing Code is hereby deleted and replaced by Title 7. Chapter 5, Section 108.2 of Article I, of the San Leandro Municipal Code. 3