Reso 2011-192 - Laserfiche WebLink

Home

PLN2009 -00006; 2450 Washington Avenue October2011 Mitigated ]Negative Declaration Mitigation Measure #4: Lighting shall provide a minimum average of one -foot candles in parking lots and .25 foot candles in pedestrian areas. Maximum illumination levels shall not exceed twenty -foot candles (20 FC) at any point. Mitigation Measure #5: Prior to demolition activities, the asbestos - containing pipe insulation, sheet vinyl floor covering, floor tile and mastic, roofing materials and transite panels should be removed in accordance with the BAAQMD's Regulation 11, Rule 2. The materials should also be removed in accordance with applicable Cal -OSHA regulations regarding asbestos related work, specifically Title 8, California Code of Regulations (CCR) Section 1529, (the Asbestos in the Construction Industry Standard). These regulations will require the use of trained personnel with appropriate medical clearance and protective equipment utilizing wet methods. Mitigation Measure #6: The applicant shall cooperate with the appropriate regional, state and federal agencies to implement the regional Clean Air Plan and enforce air quality standards in compliance with General Plan Policy 31.01. Mitigation Measure #7: To minimize construction equipment emissions during construction, the project applicant shall require the construction contractor to demonstrate compliance with the Bay Area Air Quality Management District ( BAAQMD) Regulation 2, Rule 1 (General Requirements) for all portable construction equipment subject to that rule. BAAQMD Regulation 2, Rule 1 provides the issuance of authorities to construct and permits to operate certain types of portable equipment used for construction purposes (i.e., gasoline or diesel- powered.engines used in conjunction with power generation, pumps, compressors, and cranes) unless such equipment complies with all applicable requirements of the "CAPCOA" Portable Equipment Registration Rule" or with all applicable requirements of the Statewide Portable Equipment Registration Program. This exemption is provided in BAAQMD Rule 2- 1 -105. Mitigation Measure #8: The applicant shall perform low -NOx tune ups on all diesel- powered construction equipment greater than 50 horsepower (no more than 30 days prior to the start of use of that equipment). Periodic tune ups (every 90 days) shall be performed for such equipment used continuously during the construction period. Mitigation Measure #9: Applicant will be required to complete and submit an Asbestos Demolition /Renovation Notification (APCD Form ENF -28 which can be downloaded at httn:// www.sbancd.org/eng /dl/d108.htm) for each regulated structure to be demolished or renovated. Mitigation Measure #10: The applicant shall cease any grading or construction activities and shall consult with appropriate representatives of the Native American Heritage Commission if human remains are discovered, in accordance with State Law and Section 7050.5 of the Health and Safety Code, Section 15064.5 (e) of the State CEQA Guidelines and Section 5097.98 of the Public Resources Code. Mitigation Measure #11: The City of San Leandro has incorporated the 2009 International Building Code into its municipal building code (Title 7, Chapter 7 -5). The project applicant would be required to comply with all applicable State and City regulations to address potential geologic hazards associated with the proposed project, including ground 4