Laserfiche WebLink
EXHIBIT A-1 <br /> Deliverable Requirements <br /> 1. Contractor is responsible for producing contract documents that are complete and buildable. <br /> This responsibility is not discharged by issuance of documents for construction or receipt of permits. <br /> 2. Contractor is the lead designer and as such shall personally review all pages of all contract <br /> documents for completeness, correctness, and absence of conflicts. <br /> 3. All information required to build the project shall be shown. If required information is not <br /> shown on the plans or in the details then the location of said information shall be clearly noted. <br /> 4. Plans shall clearly show the work. Text shall not be written over lines or other text. Existing <br /> items/work/features shall be clearly labeled as such. Text shall plot at 3/32"tall minimum. Details <br /> shall not be called as similar unless the actual detail clearly notes what occurs at the similar location. <br /> Details shall be cut with the proper orientation. Details with reverse orientation shall be noted as OH <br /> (opposite hand) on the drawings. Words shall be completely spelled out unless an abbreviation is <br /> defined on the drawings. Plans and specs shall clearly indicate required work, for example a new <br /> reinforcing dowel shown into existing concrete shall be accompanied by the note that the contractor <br /> shall drill and epoxy said reinforcing(if that is the intent). New features/work shall be shown with a <br /> heavier line weight than existing features/work. <br /> 5. Details, plans, elevations, etc. shall be arranged and numbered on the sheets in a regular <br /> consistent pattern. <br /> 6. Specifications shall be written and printed with times new roman font at 12 point <br /> 7. Specifications shall be edited such that only materials, procedures, and execution specific to <br /> this project are included. <br /> 8. No work shown on the plans or included in the specs shall be `design build' unless it is <br /> specifically listed herein, or approved in writing by a representative of the city. <br /> 9. Plans and specs shall not be ambiguous. Where a minimum dimension or spec is given a <br /> maximum shall also be shown. <br /> 10. Plans and specs shall be coordinated to precisely specify the work. To the extent possible <br /> information will be shown in one location (i.e. either plans or specs, but not both). <br /> 11. Due consideration shall be given to construction methods. Details shall be buildable. Where <br /> items are envisioned to be precaset or prefabricated it shall be noted on the drawings. Plans shall <br /> differentiate between field welding and shop welding. <br /> Fiber Installation Nextlink Manor/Farnsworth Exhibit A-1 <br /> Page I of 2 <br />