Laserfiche WebLink
IL 35 <br />IG 35 <br />IP 35 <br />B. Additional Height Limitations for Buildings within One Hundred (100) Feet of an R Dis- <br />trict. The allowed height within one hundred (100) feet of an R District building shall <br />be limited to twenty-five (25) feet. <br /> <br />C. Height Limit May Be Adjusted. A maximum building height of fifty (50) feet in the IL <br />and IG Districts may be approved by the Zoning Enforcement Official. [The allowed <br />height within one hundred (100) feet of an IP District building shall be limited to thirty- <br />five (35) feet.] (Ord. 2001-015 § 1) <br /> <br />2-736 Maximum Lot Coverage and Maximum FAR <br /> <br />Zoning District Maximum Lot Coverage Maximum FAR <br />IL 75% 1.0 <br />IG 75% 1.0 <br />IP 40% 0.8 <br /> <br />(Ord. 2001-015 § 1) <br /> <br />2-738 Minimum Site Landscaping <br /> <br />A. General Landscape Requirements. In addition to the general Landscape Require- <br />ments prescribed in Article 19, the following requirements for minimum site landscap- <br />ing apply to all property within any I District. As part of the Site Plan Approval process <br />pursuant to Article 25, exceptions to the stated requirements for “minimum site land- <br />scaping” may be permitted in cases where such standards are found not to be practi- <br />cal due to pre-existing site constraints. <br /> <br />B. Minimum Site Landscaping. The minimum percentage of the site that shall be used <br />for landscaping shall be as prescribed below: <br /> <br />Zoning District Minimum Site Landscaping <br />IL 5% <br />IG 5% <br />IP 15% <br /> <br />(Ord. 2001-015 § 1) <br /> <br />2-740 Parcels Adjoining Residential Districts—Additional Development <br />Regulations for New Construction <br /> <br />A. Intent. The purpose of this section is to reduce the potential negative impacts of ex- <br />panding industrial activities to the residents within adjoining Residential Districts by <br />Exhibit D: Proposed Amended Article 7 Page 28 <br />Note: underline and bolded text represents new text; strike-through text represents text to be eliminated <br />