Laserfiche WebLink
COPCs; other analyses may be required, based on the intended disposal or <br /> re-use of the water. <br /> • Additional Soil Management Protocols During Construction Activities: Soil <br /> with residual COPCs may be present on-site. Subsurface investigations <br /> planned for the Sites will determine the presence or absence of COPCs in <br /> soils. Once soils are tested, a Site specific soil management plan(SMP)will <br /> be prepared. At the present time, there are no known chemical source areas <br /> or areas of soil contamination on either Site. The protocols to be followed <br /> in the event that unknown areas of contamination are identified during <br /> development are described in this section. <br /> • Procedures for Discovery of Unknown Areas of Contamination: Site <br /> development activities may result in the identification of previously <br /> unknown areas or types of contamination. Unknown conditions which may <br /> trigger contingency monitoring procedures during site development include, <br /> but are not limited to, the following: <br /> • Oily, shiny, or chemical saturated soils; <br /> • Soil with a significant chemical or hydrocarbon-like odor; or <br /> • Significantly discolored soils. <br /> Upon the discovery of one of the conditions identified above, the contractor will <br /> conduct the contingency monitoring. Contingency monitoring, if conducted, <br /> will consist of the following steps: If unknown areas of potential discolored <br /> soils are encountered, additional analyses should be conducted for the suspected <br /> constituents to assess the actual composition of the suspected contamination. A <br /> State environmental regulatory agency should be contacted for assistance in <br /> determining if additional sampling and potential mitigation is necessary. If the <br /> encountered materials are suspected to contain volatile organic chemicals, the <br /> following contingency monitoring procedures may be followed: <br /> Conduct contingency monitoring by taking organic vapor readings using an <br /> organic vapor meter (OVM) or an organic vapor analyzer (OVA) to screen for <br /> the presence of fuel, oil, or solvents. If the OVM/OVA indicates that an <br /> unknown area of fuel, oil, or solvents has been detected, then a State <br /> environmental regulatory agency should be notified to determine if additional <br /> sampling is appropriate prior to continuing construction in that area. OVM or <br /> equivalent screening methods will be conducted by experienced personnel only. <br /> If an unknown area of soil contamination has been identified, and the State <br /> environmental regulatory agency requests additional characterization, the <br /> following steps will be taken: <br /> o Soil samples will be collected from the identified area and analyzed for <br /> the likely COPC, depending on the suspected type of contamination. <br /> The sampling strategy will be discussed with a State environmental <br /> regulatory agency prior to the initiation of the sampling activities. <br /> Analytical results collected from the suspected source will be compared <br /> Agreement to Conditions April 21,2014 <br /> PLN2013-00045 Page 10 of'�- <br />