Agmt 2019 MLA for Small Cell Pole Attachment

Home

under Subsection 7.1.2 (Identification and Other Signage). Plans and specifications shall be prepared in strict accordance with codes referenced in Section 13.4 (Compliance with Electrical Code), as stamped/signed by a California -licensed engineer. Licensee's plans and specifications and any Equipment installed, if authorized, shall comply with the minimum requirements provided in Exhibit B to this Master License, attached to and incorporated herein. Licensee expressly agrees that these minimum requirements are an exercise of the City's proprietary interests as the owner of the City Poles and are not an exercise of the City's regulatory authority. Licensee is authorized to install Equipment at the License Area covered by the Pole License only in strict compliance with the plans and specifications approved by the City and, if applicable, in compliance with Regulatory Approvals (hereinafter referred to as "Approved Plans"). 7.1.2 Identification and Other Signage. Licensee shall place one identification plate in size, material, form, and substance strictly complying with the Approved Plans on its Equipment at each Pole Location, and one identification plate with the same information on the ground near the Pole. The plates shall include Licensee's corporate name and the telephone number at which Licensee's on-call representative listed in the Basic License Information can be reached. If Licensee's on-call representative changes, Licensee must provide notice to the City of the new contact information within 72 hours and replace all identification plates within 10 business days. Licensee may also place signage on Licensee's Equipment that contains information and disclosures required by the Federal Communications Commission (the "FCC"). Replacement of Licensee's signage will be considered maintenance subject to Section 10.5 (Licensee's Equipment). 7.1.3 Required Changes. Licensee may amend previously Approved Plans if required to obtain or comply with other Regulatory Approvals necessary for installation of Equipment, including construction or installation -related temporary street occupancy permits, traffic control permits, and building permits, as may be required by City or State of California codes. Amendment of Approved Plans will require the City's approval. Licensee acknowledges that as of the Effective Date of this Master License, the City has not approved or promised to approve any plans, specifications, or permits necessary for Licensee to install Equipment on any City Poles. The City will provide notice of its decision in accordance with Section 28.1 (Notices). 7.1.4 Corrections. The City's approval of plans, specifications, and amendments to Approved Plans, and the issuance of related Regulatory Approvals will not release Licensee from the responsibility for and obligation to correct any errors or omissions that may be contained in the Approved Plans and related Regulatory Approvals. Licensee shall notify the Engineering and Transportation Department immediately upon discovery of any omissions or errors, and Licensee shall obtain required approvals of any amendments to previously Approved Plans before proceeding with any current or pending equipment installation. 7.2 Installation. Licensee shall not commence installation of Equipment on the License Area until the City has given Licensee notice to proceed by delivery of the countersigned copy of the Acknowledgment Letter confirming the Commencement Date under Section 4.1.2 (Commencement Date) and by issuing the Encroachment Permit under Section 6.2 (Regulatory Approval Required). When installing Equipment, Licensee must strictly comply with the Encroachment Permit and Approved Plans as originally approved, or, if applicable, as amended or corrected. 7.3 Notice Required Prior to Installation. Licensee shall not commence installation of Equipment on the License Area until Licensee has provided at least 24 hours' prior notice of the installation, by first requesting an 17