Laserfiche WebLink
The factory bumper shall be removed and replaced with a custom fabricated, heavy duty aluminum bumper and grille <br />protection assembly. <br />THERE SHALL BE NO OFF-ROAD LIGHT HOLES IN THE BUMPER <br />BUMPER SHALL BE MOUNTED AS CLOSE TO THE CHASSIS AS POSSIBLE IN ORDER TO REDUCE THE OVERALL LENGTH OF THE <br />VEHICLE <br />LICENSE PLATE BRACKET SHALL BE SHIPPED LOOSE WITH THE TRUCK <br />596572.3 - SHOVEL STORAGE TUBES, FRONT BUMPER <br />Two (2) shovel storage tubes shall be installed on the rear face of the grille guard uprights, one (1) each side. See picture <br />100058.1 - REAR MUD FLAPS <br />The chassis shall be supplied with mud flaps with the manufacturer's logo. The mud flaps shall be installed behind the rear <br />wheels. <br />100063.1 - FRONT BUMPER SKID PLATE <br />A .250" aluminum skid plate will be installed from the bumper area extending below the bumper extension and chassis <br />radiator area. <br />100065.1 - TRANSFER CASE SKID PLATE, LONG <br />A removable heavy .250" aluminum skid plate assembly shall be installed to protect the oil pan and transfer case. <br />100111.3 - CAB STEPS <br />The cab shall be equipped with steel tubing step assemblies, on each side of the cab. <br />100086.4 - CUSTOM FABRICATED CONSOLE AND SWITCH PANEL <br />A custom fabricated poly (plastic) electrical console and enclosure shall be located between the driver's and passenger's <br />seats. It shall house the siren, switches, cup holder, and auxiliary equipment. <br />LAYOUT TO MIRROR 14333 <br />100543.3 - 12 VOLT POWER SOURCES <br />Four (4) 12 volt plug-in utility power outlets rated at 15 amps shall be provided in cab. <br />LOCATIONS: Center console <br />100081.1 - WINCH -- FRONT MOUNTED <br />A Warn Winch Company Model #M15000 PN47801 15,000 pound capacity 12-volt electric powered winch shall be shall be <br />permanently installed at the front center bumper extension area . The unit shall include the following: <br />a) 3.86 feet per minute pulling speed at 12,000 lb rated load <br />b) 440 amps at full capacity <br />c) Cable roller guide assembly <br />d) 90 feet of 7/16" diameter galvanized cable and hawse fairlead & safety hook assembly shall be supplied. <br />e) Winch speed shall be constant with forward and reverse modes controlled with a push button device at the end of a 12 <br />feet (12') minimum control cable which connects to the winch through a weatherproof receptacle. <br />100178.1 - REAR RECEIVER <br />The rear of the chassis shall be equipped with one (1) square steel tube receiver assembly for high or low angle rescue, <br />trailer use, and winch applications. It shall be the same size as a Class III trailer hitch and shall be attached to the chassis <br />frame assembly. The receiver shall be rated at approximately 10,000 lbs. <br />100242.3 - FIRE PUMP SPECIFICATIONS <br />A Hale HPX75-KBD 24 fire pump with diesel engine radiator cooled shall be installed on the apparatus to meet the following <br />performance criteria: <br />155 GPM @ 50 PSI <br />Skeeter Brush Trucks Page 5 12/03/2020130