Laserfiche WebLink
<br />Energport Inc Page 23 /24 <br />1. Overheat: Under normal circumstances, battery cooling system will automatically cool <br />down the battery system to the optimal operating temperature range when the battery system <br />battery overheating. When the battery system not dropping to the target temperature within the <br />specified time or battery cooling system temperature exceeds the upper limit of safe use, the <br />management system will give a warning and asked to immediately stop using. In this case, you <br />should immediately stop using the battery, and notify the relevant technical staff to conduct a <br />comprehensive inspection and troubleshooting before use. <br />2. Electric Leakage: If customer find the battery system leaking, it must immediately evacuate <br />personnel in the room, and immediately notify the relevant technical personnel to the scene <br />processing, troubleshooting before use. Strictly prohibit battery to work sick, or to force to be used. <br />3. Over discharge: When the battery energy is exhausted, the overall voltage is too low or the <br />cell voltage is lower than the individual normal operating voltage range. The management system <br />will be given a warning and asked to immediately stop using the battery and charging. You should <br />immediately stopping discharge of the battery and start charging. Prohibit forcing to continue to <br />discharge the battery at this time and it will damage the battery performance and may result in <br />permanent damage to the battery in severe cases. <br />4. Short Circuit: all causes short circuit of the battery system, you must immediately evacuated <br />personnel in the room. Immediately you must disconnect the battery from the system and cut off <br />power and relevant electrical equipment (if possible), and immediately notify the relevant technical <br />staff site to repair troubleshooting. The short-circuit battery will not be re-used and must be fully <br />tested by the manufacturer before determining whether they can continue to use. <br />5. Combustion: Customer must immediately evacuate personnel in all causes burning incident <br />in the room. Within safety limits, any unrelated persons are forbidden to be close to the storage <br />room (because of possible risk of explosion). Professional personnel should use fire extinguishers <br />to put out the fire. After fire is put out, personnel wearing protective equipment cut off the power <br />and the battery is fully discharged by resistance (voltage to zero volts), before removing the battery <br />system for subsequent operations analysis. <br />6. Battery system Crash: Due to various reasons, if the battery system is crashed, deformation <br />or body piercing, customer should immediately disconnect the battery power cable and inform <br />professional and technical personnel to the scene to remove the battery system. Customer should <br />let the personal who wears protective equipment required to make sure the battery is fully <br />discharged before the demolition work. <br />7. Other accidents: when customer need to repair or remove the battery system due to other <br />accidents. Customer should first disconnect the battery line and ensure that the battery will not be <br />short-circuited, then remove the battery system and ensure that the battery system will not be <br />collisions, drop, inversion and other conditions. Or else, please refer to the above regulations. <br />DocuSign Envelope ID: 1DDC1773-ED91-404B-97DD-AC3EFDBAD0DD