Laserfiche WebLink
KT-LED7T8-24GC-840-DX2 <br />T8 LED LAMP <br />Page 2 of 3 <br />Connect wires directly to these terminals <br />Typical Non-Shunted Lampholder <br />CAUTION: For Single- <br />ended wiring use only <br />non-shunted lampholders. <br />For Single-ended wiring, do not <br />install product in a fixture with <br />shunted lampholders (found in <br />all fixtures using instant start bal- <br />lasts). If the current lampholders <br />are shunted, remove them and <br />replace them with non-shunted <br />lampholders. Make new con- <br />nections directly to terminals as <br />indicated above. <br />Keystone can provide any style <br />replacement lampholders. <br />Call us at 800-464-2680. <br />SINGLE-ENDED WIRING DIAGRAM <br />Figure A Typical Ballast Configurations: <br />PROGAM START <br />LINE <br />NEUTRAL <br />YELLOW <br />YELLOW RED <br />RED <br />BLUE <br />BLUE <br />LAMP <br />LAMP <br />BALLAST <br />PREHEAT WITH STARTER <br />LINE BLACK <br />BALLAST <br />LAMP <br />S <br />INSTANT START <br />LINE <br />NEUTRAL <br />BLUE <br />BLUE <br />RED <br />LAMP <br />LAMP <br />BALLAST <br />2. Re-wire fixture as shown below. <br />1. Cut all existing connections to ballast as shown below and remove ballast. See Figure A for typical <br /> ballast configurations. Note: Single-ended wiring requires non-shunted lampholders. <br />CAUTION: INSTANT START BALLASTS <br />HAVE SHUNTED LAMPHOLDERS. <br />DOUBLE-ENDED WIRING DIAGRAM <br />POWER SOURCE <br />LINE NEUTRAL <br />NEUTRAL <br />LINE Direct Drive LED Tube <br />Direct Drive LED Tube <br />Direct Drive LED Tube <br />Direct Drive LED Tube <br />No Live <br />ConnectionSide ASide BSide ASide BSide ASide ASide BSide B1. Cut all existing connections to ballast as shown below and remove ballast. See Figure A above for <br /> typical ballast configurations. <br />NEUTRALLINEDirect Drive LED Tube <br />Direct Drive LED Tube <br />Direct Drive LED Tube <br />Direct Drive LED TubeSide ASide BSide ASide BSide ASide ASide BSide BShunted Lampholders <br />NEUTRALLINEDirect Drive LED Tube <br />Direct Drive LED Tube <br />Direct Drive LED Tube <br />Direct Drive LED TubeSide ASide BSide ASide BSide ASide ASide BSide BNonshunted Lampholders <br />2. Re-wire fixture as shown below. For Double-ended wiring, use either shunted or nonshunted lampholders. <br />Note: There should not be any exposed wires at the end of installation. <br />Keystone Technologies • Philadelphia, PA • Phone (800) 464-2680 • www.keystonelamp.com <br />Specifications subject to change. Last revised on November 15, 2019 1:50 PM <br />DocuSign Envelope ID: 64BB0189-33AC-48E9-B1D7-D912FB4998D8