Inst 2017011823 - Laserfiche WebLink

Home

Substances Control technical document titled, "Information Advisory on • Clean Imported Fill Material". The developer's environmental consultant shall approve the use of imported fill. 10. Mitigation Measure #10: Prior to issuance of a grading permit, the project applicant must prepare and implement an erosion and sediment control plan (ESCP) including interim and permanent erosion and sediment control measures, and a pollutant control plan(PCP). 11. Mitigation Measure #11: Prior to issuance of a grading permit, the project applicant shall file the required documentation to the State Water Resources Quality Board and prepare a Storm Water Pollutant Prevention Plan (SWPPP) which will be reviewed and approved by the City Engineer. The City Engineer must conduct inspections prior to issuing a certificate of occupancy, to ensure that requirements are complied with. 12. Mitigation Measure #12: The applicant will comply with applicable waste discharge requirements and municipal code requirements including preparation of a SWPPP for construction activities and compliance with the Alameda Countywide Clean Water Program (ACCWP). These permit programs are designed to prevent violation of water quality standards through mitigation and control of pollutant transport in storm water runoff and infiltrating waters. The City of San Leandro Municipal Code ensures that permit conditions are met. 13. Mitigation Measure#13: Applicant shall be required to demonstrate adequacy of the existing storm drain system to handle existing run-off from the drainage basin as well as run-off from the project, upgrade the storm drain system to handle existing run-off from the drainage basin as well as run-off from the project, or meter run-off from the site so that it leaves the site at the same rate as it currently does. 14. Mitigation Measure #14: Applicant shall remove pollutants from storm water prior to discharging the water from the site per the current NPDES permit 15. Mitigation Measure #15: All commercial construction shall comply with the City's existing building codes related to sound attenuation. 16. Mitigation Measure#16: All construction activity shall comply with the City's Noise Ordinance (Municipal Code Chapter 4-1, Section 11) so as not to make or cause disturbing, excessive or offensive noise which causes annoyance or discomfort to persons. 17. Mitigation Measure #17: The minimum levels of service standards for police and fire response times shall be maintained in accordance with General Plan Policy 45.01. 18. Mitigation Measure #18: The applicant shall incorporate lighting, landscaping and other design features that reduce the potential for crime and facilitate rapid response to emergency calls in accordance with General Plan Policy 45.06. Agreement to Conditions April 21,2014 PLN2013-00045 Page 12 of,25 a-y