Laserfiche WebLink
Scope of Work: <br />1. Inspect roof and cut out any blisters, mole runs, and damaged areas. Apply Green <br />Lock Membrane adhesive inside cut and apply new cap sheet membrane. <br />2. Remove and dispose of all base flashings, detail flashings, and coping metal. <br />3. Replace base all flashings with Flexbase 80 and StressPly E FR Mineral in Green -Lock <br />Flashing Adhesive. <br />4. Power wash roof system with simple green or tsp and water solution. Ensure the roof is <br />free of all dirt, debris, and contaminants. <br />5. Coat all base flashings with Pyramic Base and Pyramic. (1.5+ 1.5) <br />6. Apply Garla-Block primer at 1/2 gallon per square. <br />7. Install 6" Uni-Bond Tape across all seams. Use a roller to ensure the tape is firmly <br />fastened. Install Uni-Bond at all detail flashings and base flashings. <br />8. Roll White -Knight Pius WC over uni-bond. Very light, just need to get the texture of the <br />tape covered (1 /2 gal needed at most). <br />9. Apply White -Knight Plus WC base coat and top coat. 2 gallons per square on each <br />coat. <br />10. Install new Pre -Formed ANSI-SPRI ES -1 Coping. <br />Line Item Pricing <br />Item # <br />Item Description <br />Unit Price <br />Quantity <br />Unit <br />Extended Price <br />NEW FLASHINGS FOR ROOFING SYSTEMS & <br />RESTORATION OPTIONS: ROOF FLASHINGS <br />FOR MODIFIED & COAL TAR PITCH ROOF <br />SYSTEMS: <br />Minimum 1 Ply of Base Flashing and Mineral Cap <br />Sheet Installed in Hot ASTM D 312 Type III or IV <br />20.11.04 <br />Asphalt: FLASHING OPTION: - BASE PLY: SBS <br />Modified Fiberglass Reinforced Base Flashing Ply <br />w/ Tensile Strength of 215 Ibf/in tensile (ASTM D <br />5147); TOP PLY: ASTM D 6162 SBS <br />Fiberglass/Polyester Reinforced Modified <br />Bituminous Sheet Material Type III - 500 Ibf/in <br />tensile <br />$__1 5,96 <br />4500 <br />SF <br />$ 711820 <br />NEW FLASHINGS FOR ROOFING SYSTEMS & <br />RESTORATION OPTIONS: ROOF FLASHINGS <br />FOR MODIFIED & COAL TAR PITCH ROOF <br />SYSTEMS: <br />Minimum 1 Ply of Base Flashing and Mineral Cap <br />20.999 <br />Sheet Installed in Hot ASTM D 312 Type III or IV <br />Asphalt: - PER SQUARE FOOT COSTS - <br />INSTALLING IN COLD PROCESS FLASHING <br />ADHESIVE <br />Substitute Hot Asphalt Application for Cold Process <br />Flashing Adhesive Application of Flashings <br />$ 6.49 <br />1 4500 <br />SF <br />$ 297205 <br />Page 2of4 <br />