Reso 2020-125 Verizon Wireless Master Agreement Small Cell Pole

Home

and specifications must cover all Equipment, including signage required or permitted under Subsection 7.1.2 (Identification and Other Signage). Plans and specifications shall be prepared in strict accordance with codes referenced in Section 13.4 (Compliance with Electrical Code), as stamped/signed by a California -licensed engineer. Licensee's plans and specifications and any Equipment installed, if authorized, shall comply with the minimum requirements provided in Exhibit B to this Master License, attached to and incorporated herein. Licensee is authorized to install Equipment and perform permitted modifications at the License Area covered by the Pole License only in strict compliance with plans and specifications approved by the City and, if applicable, in compliance with Regulatory Approvals (hereinafter referred to as "Approved Plans"). 7.1.2 Identification and Other Signage. Licensee shall place signage on its Equipment at each Pole Location containing (i) Licensee's emergency phone number; and (ii) a unique pole identification number identifying the location of Licensee's pole; and (iii) complying with Federal Communications Commission (the "FCC") signage requirements. 7.1.3 Required Changes. Licensee may amend previously Approved Plans if required to obtain or comply with other Regulatory Approvals necessary for installation of Equipment, including construction or installation -related temporary street occupancy permits, traffic control permits, and building permits, as may be required by City or State of California codes. Amendment of Approved Plans will require the City's approval. Licensee acknowledges that as of the Effective Date of this Master License, the City has not approved or promised to approve any plans, specifications, or permits necessary for Licensee to install Equipment on any City Poles. The City will provide notice of its decision in accordance with Section 28.1 (Notices). 7.1.4 Corrections. The City's approval of plans, specifications, and amendments to Approved Plans, and the issuance of related Regulatory Approvals will not release Licensee from the responsibility for and obligation to correct any errors or omissions that may be contained in the Approved Plans and related Regulatory Approvals. Licensee shall notify the Engineering and Transportation Department immediately upon discovery of any omissions or errors, and Licensee shall obtain required approvals of any amendments to previously Approved Plans before proceeding with any current or pending equipment installation. 7.2 Installation. Licensee shall not commence installation of Equipment on the License Area until the Pole License Effective Date of the applicable Pole License Qty has „en LiGensee notice t proceed by delivery of the GGURtersigRed GE)PY of the AGkRewledgment Letter GenfiFrning the rr..,,.,,,,r,..r.., eRt Date under SeGtjn!3 I I ? iGr...,,,,r..,..r... eRt n.,+.,� and by issuing the issuance of an Encroachment Permit under Section 6.2 (Regulatory Approval Required). When installing Equipment, Licensee must strictly comply with the Encroachment Permit and Approved Plans as originally approved, or, if applicable, as amended or corrected. 7.3 Notice Required Prior to Installation. Licensee shall not commence installation of Equipment on the License Area until Licensee has provided at least 24 hours' prior notice of the installation, by first requesting an inspection using the City's Inspection Hot -Line telephone system, 510-577-3308, to disclose the Encroachment Permit number and License Area location. 7.4 Cost of Labor and Materials. Licensee is responsible for all direct and indirect costs (labor, materials, and overhead) incurred by Licensee for designing, purchasing, and installing Equipment in accordance with the 17