Impec Group NPSA 20240401 - Laserfiche WebLink

Home

Non-Professional Services Agreement between April 1, 2024 City of San Leandro and Impec Group—Exhibit D Page 35 of 36 c. The lawyers’ conference room will be cleaned as needed. 11. The overhead area will be wiped down once every two weeks and the air vents will be cleaned at least every two weeks. 12. The alcove area outside the jail entrance will be swept daily and washed down when necessary. 13. Communication Center – Each communication center (5 total) shall be thoroughly cleaned (wiped down to remove food/liquid stains) and dusted once per week, as permitted by the Watch Sergeant. K. General (As Requested) 1000 Wax and Buff Vinyl Tile Floors 1. Prior to being waxed and buffed, the tile floor area shall be swept, vacuumed and completely wet - mopped. 2. The floor shall be evenly coated with wax to within 2 inches of the walls; a single disc floor machine shall be used to restore a uniform gloss and protective finish to the floors, which are coated with metal-link polymer floor finish. 3. The floor finish shall be the same type as that already on the floor. 4. The floor shall be dust-mopped after being buffed. 5. After waxing and buffing, the area shall have a uniform glossy appearance, free of scuff marks, heel marks, and scratches. 6. All wax shall be removed from baseboards, furniture, trash receptacles, etc. 1010 Stripping and Refinishing VCT and Linoleum Floors 1. Stripping is the complete removal, without damage to the floor surface, of all finish and/or sealer from all visible floor surfaces and from those floor surfaces which can be exposed by the removal of non - fixed furnishings, baseboards, door bottoms, etc. 2. Stripping also includes the complete removal of all marks, scuffs, and stains, etc., except in cases in which there is damage to the floor surfaces. 3. Where stripping chemicals are used, the areas shall be rinsed to completely remove any traces of the solution. 4. The pH of the floor surface shall be brought to neutral (pH of 7) after stripping by rinsing with a mild acid base detergent. 5. Stripping solution shall be wiped off immediately from baseboards and other fixed items in the area. 6. During the stripping process, care shall be taken to avoid floodin g the floor with either the stripping solution or the rinse so as to prevent damage to the tile and its bond to the sub -floor. 7. Prior to and after the service, all furniture shall be moved as necessary. Note: The job shall not be considered complete until the furniture is returned to its original location. 1. To refinish the floors after the floor has been stripped, two coats of sealer shall be applied. 2. Then at least two coats of metal interlock polymer floor finish shall be applied. Only every other coat shall be applied all the way to the baseboard. 3. The alternating coat shall be applied so as to leave a 12" border around the area. 4. The coats shall be thin and evenly applied. After the finish has dried, the reflectance shall be uniform and no streaks, swirls, etc., shall be visible. 5. No finish shall be left on the baseboards or other fixed equipment in the area. DocuSign Envelope ID: ED026586-45BF-457C-B317-CC6A9075C2DC